Snapper MCRP215015KWV User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
2.5 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move
to desired cutting height. See Figure 2.7.
IMPORTANT: Move rear height adjustment latch for rear
wheel adjustment to correspond with raising or lowering
the front wheels to maintain the level of the deck.
FIGURE 2.7
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.8.
FIGURE 2.8
2.6 RECYCLING OPERATION
NOTE: For best recycling results, cut up to a maximum of
1/3 of grass blade length and recycle ONLY when grass is
dry.
1. Set all wheels in the highest cutting position (Notch 6).
2. Move engine speed control to “FAST” (Rabbit)
position.
3. Move ground speed control to slowest speed setting.
4. Proceed mowing slowly. If grass is very dense, lower
each rear wheel latch one notch lower than the front
wheel latches to improve recycling performance.
2.7 INSTALLATION of GRASS CATCHER
Install grass catcher by sliding connector over flange of
adapter. See Figure 2.9. Attach grass bag hooks over
middle handle cross bar. See Figure 2.10.
WARNING
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently and replace worn or damaged components
immediately.
FIGURE 2.9
FIGURE 2.10
REMOVE HAIR PIN
AND CLEVIS PIN
SHOWN IN
LOWEST CUTTING
HEIGHT
HIGHEST CUTTING
HEIGHT
SWIVEL
WHEEL
MODEL
FIXED
WHEEL
MODEL
LATCH
1 LOWEST
CUTTING
HEIGHT
6 HIGHEST
CUTTING
HEIGHT
1
2
3
4
5
6
LATCH
POSITIONS
1
2
3
4
5
6
POSITION BAG
BETWEEN HANDLES
SLIDE
CONNECTOR
DOWN OVER BAG
ADAPTER FLANGE
BAG
ADAPTER
CONNECTOR
ATTACH BAG HOOKS OVER
MIDDLE HANDLE CROSS BAR
MIDDLE
HANDLE
CROSS
BAR
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments