Snapper MCRP215015KWV User Manual download pdf (Page 15)

Section 4 - ADJUSTMENTS & REPAIR

WARNING

DO NOT attempt any maintenance, adjustments or

service with engine and blade running. STOP engine

and blade. Disconnect spark plug wire and secure

away from spark plug. Engine and components are

HOT. Avoid serious burns, allow sufficient time for

all components to cool.

4.3.4. Replacing Rubber Driven Disc

(Continued from previous page)

2. Using needle nose pliers, unhook the drive spring

and slide the driven disc assembly off the hex shaft.

See Figure 4.12.

3. Remove the two retaining rings which secure the

rubber driven disc to the driven disc assembly. See

Figure 4.13.

4. Install new rubber driven disc onto driven disc

assembly with retaining rings.

5. Reverse above procedures for reassembly and

installation of driven disc assembly.

FIGURE 4.12

4.3.5. Replacing Bearing In Driven Disc Assembly

If the driven disc bearing fails, remove the driven

disc assembly and replace bearing as follows:

1. Remove snap ring. See Figure 4.13.

FIGURE 4.13

2. Slide the hub assembly out of the bearing.

3. Remove the four screws.

4. Remove bearing and replace with new bearing.

5. Reassemble components in reverse order.

DRIVEN DISC

ASSEMBLY

THRUST PLATE

SNAP

RING

SHIM

WASHER

REMOVE FOUR

MACHINE SCREWS

BEARING

DRIVEN

DISC

PLATE

DRIVEN DISC

HUB

RUBBER DISC

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments

Snapper MCRP215015KWV User Manual Page 15

Comments to this Manuals

Related products and manuals for Lawnmowers Snapper MCRP215015KWV